Glue for foamglass, polyfoam, basalt cotton wool, expanded polystyrene
To buy glue for foamglass, polyfoam, basalt cotton wool, expanded polystyrene in Kiev.
Glue are divided into two look: for gluing, and for reinforcing. Glue is intended for gluing of foamglass, a minvata, polyfoam, expanded polystyrene. Clay for reinforcing creates an additional hydroprotective layer. Also except glue the heater is in addition recommended to strengthen the expansion bolt shield umbrella, and during creation of the reinforcing layer to use a steklotkanny grid. Expense: 4-6¬ú/sq.m.
Dry mix gets divorced water. Solution is kneaded by a mixer or the mixer before formation of homogeneous mass. It can be used within 2 hours.
Mix is applied in the form of strips at distance in 2 cm if the surface of a wall has roughnesses to 5,0 mm on all perimeter of a plate, and after and in the middle. If roughnesses to 15 mm., solution is applied on a surface in the form of strips at distance of 2 cm from edge on perimeter, and in the middle of a plate 5-7 indicators are put. If the surface has roughnesses to 3 mm, solution is applied with the gear pallet on all surface of a plate of foamglass.
The block of foamglass needs to be pressed that 40% of mix were distributed between the basis and a plate. Plates fasten closely to each other, without coincidence of vertical seams. Width of seams should not be more than 2 mm. The remains of mix are removed water before hardening.